提示
王琪
-
64浏览
-
0点赞
-
0收藏
-
0分享
-
178下载
-
0评论
-
引用
期刊论文
Preparation of Polypropylene/Carbon Nanotube Composite Powder with a Solid-State Mechanochemical Pulverization Process
Journal of Applied Polymer Science, Vol. 93, 378-386 (2004)，-0001，（）：
A solid-state mechanochemical pulverization process, that is, pan milling, was used to prepare a polypropylene (PP)/carbon nanotube (CNT) composite powder. The composite powder was then melt-mixed with a twin-roll masticator to obtain a PP/CNT composite. The morphology of the PP/CNT powder and the PP/CNT composite was investigated. The crystallization and mechanical properties of the latter were also studied. After 20 milling cycles (ca. 60min), the average diameter of PP/3wt% CNT composite powder particles was a few micrometers. The length of the CNTs was reduced from a few micrometers to 0.4-0.5
【免责声明】以下全部内容由[王琪]上传于[2005年07月07日 22时26分26秒]，版权归原创者所有。本文仅代表作者本人观点，与本网站无关。本网站对文中陈述、观点判断保持中立，不对所包含内容的准确性、可靠性或完整性提供任何明示或暗示的保证。请读者仅作参考，并请自行承担全部责任。
本学者其他成果
同领域成果
