-
38浏览
-
0点赞
-
0收藏
-
0分享
-
220下载
-
0评论
-
引用
期刊论文
Measuring the Gas Flow From a Supersonic Nozzle Used in a 1.5-MA Gas Puff Z Pinch
IEEE TRANSACTIONS ON PLASMA SCIENCE, VOL. 30, NO.2, APRIL 2002,-0001,():
A supersonic nozzle for a 1.5-MA gas puff pinch was designed and the gas flow injected out from the nozzle was measured. A miniature ionization gauge was developed to measure the density profile of the gas shell and two pressure transducers were used for determining the Mach number of the gas flow. It was found that the gas flow is not distributed symmetrically about 0, the mean radius of the exit aperture, and the radial location for the peak of the density profile moves inwards as time goes on. When the plenum pressure is 5atm, the maximum line mass density measured was 43g/cm and the Mach number of the gas flow deduced from experiments is 4.3, which is close to the expectation: a line mass density of about 50g/cm and a Mach number higher than 4. The measurements indicate that if a plenum opens into a large dead volume via a finite opening valve in a gas-puff system it will not produce a steady-state solution. Then, any agreement between the measurements and the calculations based on the steady state should not be expected.
【免责声明】以下全部内容由[王新新]上传于[2006年07月05日 22时36分37秒],版权归原创者所有。本文仅代表作者本人观点,与本网站无关。本网站对文中陈述、观点判断保持中立,不对所包含内容的准确性、可靠性或完整性提供任何明示或暗示的保证。请读者仅作参考,并请自行承担全部责任。
本学者其他成果
同领域成果