-
34浏览
-
0点赞
-
0收藏
-
0分享
-
120下载
-
0评论
-
引用
期刊论文
Study on Pre-stress Hard Cutting of Bearing Races
,-0001,():
The analysis on load characteristics and stress state of bearing races shows that the roll path and outside layer of a bearing race are the main part to bear the load, and that residual tensile stress is often found on workpiece surface. For the purpose of improving residual stress state on machined surface of a bearing race, a method of pre-stress hard cutting is put forward. In this paper, the principle of pre-stress cutting is introduced, and method of loading stress on bearing races, together with the calculation for pre-stress, is analyzed. A set of device with expanding mandrel for realizing the process is designed too and an experiment of pre-stress cutting is carried out on a lathe with PCBN tool. The experimental results show that, by using this method, we can get residual compressive stress on machined surface layer of a bearing race and increase the quality and contact fatigue life of bearing.
【免责声明】以下全部内容由[叶邦彦]上传于[2007年04月10日 19时27分50秒],版权归原创者所有。本文仅代表作者本人观点,与本网站无关。本网站对文中陈述、观点判断保持中立,不对所包含内容的准确性、可靠性或完整性提供任何明示或暗示的保证。请读者仅作参考,并请自行承担全部责任。
本学者其他成果
同领域成果