-
78浏览
-
0点赞
-
0收藏
-
0分享
-
288下载
-
0评论
-
引用
期刊论文
Fault Location Using Traveling Wave for Power Networks
,-0001,():
Fault location using traveling wave has been applied inextra-high voltage power grids successfully. Due to itscomplication and high cost, it is not easy for this technique to beaccepted for use in distribution system. A new traveling wavefault location system is developed simply in a cost-effective wayfor power networks (especially for distribution system) in thispaper. Two traveling wave sensors are developed to capture thecurrent traveling wave flowing from the capacitive equipment toearth and the voltage traveling waves in all three phases. Theoutputs of the sensors are then applied to the trigger and timetagging by using Global Position System (GPS) receiver. Thefault position is calculated by the traveling wave arrival times inevery power station where only one fault locator is installed. Thefault location system is tested in the power system. Testing resultsshow that the fault locator has high precision and robustness.
【免责声明】以下全部内容由[曾祥君]上传于[2005年07月25日 18时21分40秒],版权归原创者所有。本文仅代表作者本人观点,与本网站无关。本网站对文中陈述、观点判断保持中立,不对所包含内容的准确性、可靠性或完整性提供任何明示或暗示的保证。请读者仅作参考,并请自行承担全部责任。
本学者其他成果
同领域成果