In this paper, we consider a 2-hop wireless diversity relay network. We explore transmit power allocation among the source and relays to maximize the received signal to noise ratio (SNR) at the destination. We consider two relay protocols," amplify and forward" (AAF) and" decode and forward" (DAF) and design the respective power allocations for both uncoded and coded systems. For a 2-hop relay system with one relay node, we derive a closed-form power allocation solution and, based on it, we propose a relay activation condition. If and only if the fading channel coefficients satisfy this condition, the relay transmits the signals to the destination; otherwise, the relay will stay in the idle state. For a system with more than one relay node, general closed-form power allocation solutions based on an extact SNR expression are difficult to derive; we hence, calculate a SNR upper bound and derive a sub-optimum power allocation solution based on this bound. The simulation results show that for a 2-hop diversity relay channel with one relay node the proposed adaptive power allocation (APA) scheme yields about 1−2dB SNR gains compared to the equal power allocation. This SNR gain increases monotonically as the number of relays increases.

Multimedia stream service provided by broadband wireless networks has emerged as an important technology and has attracted much attention recently. An all-IP network architecture with reliable high-throughput air interface makes orthogonal frequency division multiplexing access (OFDMA)-based mobile worldwide interoperability for microwave access (mobileWiMAX) a viable technology for wireless multimedia services, such as voice over IP (VoIP), mobile TV, and so on. One of the main features in a WiMAX MAC layer is that it can provide differentiated services among different traffic categories with individual QoS requirements. In this article, we first give an overview of the key aspects of WiMAX and describe multimedia broadcast multicast service (MBMS) architecture of the 3GPP. Then, we propose a multicast and broadcast service (MBS) architecture for WiMAX that is based on MBMS. Moreover, we enhance the MBS architecture for mobile WiMAX to overcome the shortcoming of limited video broadcast performance over the baseline MBS model. We also give examples to demonstrate that the proposed architecture can support better mobility and offer higher power efficiency.

The WiMAX standard specifies a metropolitan area broadband wireless access air interface. In order to support QoS for multimedia applications, various bandwidth request and scheduling mechanisms are suggested in WiMAX, in which a subscriber station can send request messages to a base station, and the base station can grant or reject the request according to the available radio resources. This article first compares two fundamental bandwidth request mechanisms specified in the standard, random access vs. polling under the point-to-multipoint mode, a mandatory transmission mode. Our results demonstrate that random access outperforms polling when the request rate is low. However, its performance degrades significantly when thechannel is congested. Adaptive switching between random access and polling according to load can improve system performance. We also investigate the impact of channel noise on the random access request mechanism.

Companding transform is an efficient and simple method to reduce the Peak-to-Average Power Ratio (PAPR) for Multi-Carrier Modulation (MCM) systems. But if the MCM signal is only simply operated by inverse companding transform at the receiver, the resultant spectrum may exhibit severe in-band and out-of-band radiation of the distortion components, and considerable peak regrowth by excessive channel noises etc. In order to prevent these problems from occurring, in this paper, two novel nonlinear companding schemes with a iterative receiver are proposed to reduce the PAPR. By transforming the amplitude or power of the original MCM signals into uniform distributed signals, the novel schemes can effectively reduce PAPR for different modulation formats and sub-carrier sizes. Despite moderate complexity increasing at the receiver, but it is especially suitable to be combined with iterative channel estimation. Computer simulation results show that the proposed schemes can offer good system performances without any bandwidth expansion.