Magnetic AC mode (MAC mode) atomic force microscopy (AFM), a novel type of tapping mode AFM in which the cantilever is driven directly by a magnetic field, is a powerful tool for imaging with high spatial resolution and better signal-to-noise in liquid environment. It may largely extend the application of AFM to living samples, especially those are sensitive to cantilever forces, even to multilayer tissue samples. However, there are few reports on the imaging of living cells by MAC mode AFM previously. In our present study, we explore the optimal imaging conditions of MAC mode AFM on living astrocytes and fresh arterial intima surface. We also used nude tips for PicoTREC panel (i.e., Aux in BNC, a new data collecting channel) to image living samples and discussed its difference with phase imaging. We show that living biological samples can be imaged by MAC mode AFM at details of comparable resolution as those by high resolution scanning electron microscopy. Furthermore, the combination of height, amplitude, phase and TREC panel signals provide abundant informations for the characteristics of living samples, such as topography, profile, stiffness and adhesion.

Five visible light-cured composite resins used as restoration or adhesive materials in dentistry, were irradiated with high energy plasma light (1300 mW/cm2), and contraction, rate of contraction, irradiation-induced temperature were analysed. A comparison was carried out with the same materials irradiated with a conventional halogen light (400mW/cm2). The exposure to the photoactivating lights was either continuously or sequentially in three or more intervals with 10 min between intervals. Comparing the lengths of exposure of both lights, which induced the same contraction in a given material, it was found that the exposure length to the plasma light was greatly reduced, when compared with the exposure length of the halogen light (1:10). Frequently, the final contraction of plasma-irradiated materials was lower, whereas the rate of contraction, as indicated by the linear dimensional variation curves obtained by laser beam scanning method, did not show significant differences between the two lights. The temperature increase induced by plasma light on the material did not exceed the temperature induced by conventional light.

Benzene, toluene, ethylbenzene, and xylenes (BTEX) are commonly found in crude oil and are used in geochemical investigations as direct indicators of the presence of oil and gas. BTEX are easily volatile and can be degraded by microorganisms, which affect their precise measurement seriously. A method for determining the biodegradation process of BTEX in seabed sediment using dynamic headspace (purge and trap) gas chromatography with a photoionization detector (PID) was developed, which had a detection limit of 7.3-13.2 ng L-1 and a recovery rate of 91.6-95.0%. The decrease in the concentration of BTEX components was monitored in seabed sediment samples, which was caused by microorganism biodegradation. The results of BTEX biodegradation process were of great significance in the collection, transportation, preservation, and measurement of seabed sediment amples in the geochemical investigations of oil and gas.

Several properties of dental materials are characterized by dimensional variation induced by different parameters. In this work a non-contact method used for measurement of linear dimensional variation is shown. The accuracy is ±1 k for sample length ranging from 1 to 70 mm.

This paper describes the investigation of the autoionizing states of AuI by exciting the states of 6d 21)3/2 and 6d 2D5/2 with tunable dye lasers by means of a resonance ionization time-of-flight mass spectrometer (RI-TOFMS). Many new autoionizing states were found, a few of which have narrow-linewidths of about 0.1 cm -1. The photoionization efficiencies for different channels were compared. Among the autoionizing states found so far, the highest photoionization yield is given by two newly obtained states from the state 6d 2D5/2, 3683.6cm-1 and 4636.5cm-1 above the first ionization limit. In addition, the Shore-Fano profile parameters of several autoionizing resonances were determined by a nonlinear fitting program.