The electrochemical redox processes of pyridoxine hydrochloride (VB6) at a poly (methylene blue) film modified glass carbon electrode (PMBE) in a phosphate buffer solution (PBS, pH 8.0) were studied by cyclic voltammetry. The VB6 electrode reaction with quasi-reversible characteristics was diffusion-controlled at low scan rates and adsorptioncontrolled at high scan rates. The anodic peak current positive to 0.6V (vs. SCE) was found to be proportional to the concentration of VB6 in the range of 0.010 to 1.03mg

Piezoelectric diffuse reflectance spectroelectrochemistry (PDRSEC), a new technique of diffuse reflectance spectroelectrochemistry (DRSEC) in combination with electrochemical quartz crystal microbalance (EQCM), was developed to study the electrochemical copolymerization of aniline and o-anthranilic acid in 1.0mol l−1 HClO4 and the properties of these copolymers. The DRSEC using an integral sphere was proven to possess a higher optical sensitivity at the unpolished piezoelectric quartz crystal electrodes used than the mirror reflectance spectroelectrochemistry mode. The copolymers grown from the copolymerization bath of different molar fractions of o-anthranilic acid (F1, relative to the total amount of the two monomers) showed intermediate properties between those of the homopolymers, which varied gradually with F1. The swelling/dissolution behavior of the copolymers vs solution pH was traced via the EQCM frequency and resistance signals, and its large dependence on F1 was found and discussed. In a HAc-NaAc buffer solution at pH 5.6, the amount of adsorbed lysozyme was found to be positively correlated with F1, via an EQCM impedance investigation, demonstrating the feasibility of using poly (aniline-co-o-anthranilic acid) as a load-adjustable immobilization matrix for cationic proteins. The novel PDRSEC method proposed is highly recommended for surface electrochemistry studies at relatively rough electrodes.

ance (PQCI) analysis was proposed as a novel multiparameter method for investigating the cyclic voltammetric growth of poly(o-phenylenediamine) (PoPD) thin films at Au electrodes in aqueous solutions of various pH values and the potentiostatic microetching (localized degradation) of these films in 0.10mol/L aqueous H2-SO4 for comparative examinations on polymer porosity and stability. Two potential-sweep ranges, -0.4 to 0.9 (I) and 0 to 0.9 (II) V versus SCE, and four solutions, acidic (A, 0.20mol/L H2SO4 + 0.10mol/L Na2-SO4; B, 0.10 mol/L H2SO4+ 0.20mol/L Na2SO4), neutral (C, 0.10mol/L PBS + 0.20mol/L Na2SO4, pH 7.2), and alkaline (D, 0.20mol/L NaOH+ 0.20mol/L Na2SO4) aqueous solutions, were selected for PoPD growth. The pH increase for the polymerization solution increased the molar percentage of polyaniline-like chains in PoPD, as quantified from the current peaks at 0.6 V versus a saturated calomel electrode (SCE) for the oxidation of -NH2 groups in as-prepared PoPD (grown from solutions C and D) during their redox switching in 0.10mol/L aqueous H2SO4 for the first time. The unusual PQCI responses observed at negative potentials (potential range I) in the first several potential cycles during the cyclic voltammetric growth of PoPD in acidic and neutral solutions have been reasonably explained as being due to the precipitation/dissolution of the poorly soluble phenazinehydrine charge-transfer complexes developed during redox switching of oligomers for the first time, which brought about much less compact PoPD films and their higher degradability than those grown in the same solution but over potential range II. SECM, scanning electron microscopy (SEM), and piezoelectric quartz crystal (PQC) frequency were used to estimate the sizes of etched microscale spots. In addition, the x-, y-, or z-axis movement of a Pt microelectrode of 25-μm diameter near the PQC electrode was found to influence negligibly the PQCI responses in 1.0mol/L aqueous Na2SO4 containing K4Fe(CN)6 up to 0.10mol/L, and a new protocol of dynamically electrodepositing silver microwires via the chemical-lens method was proposed for examining the local mass-sensitivity distribution on the PQC surface.

Through admittance measurements of two piezoelectric quartz crystals in parallel on one impedance analyzer and then non-linear fitting according to an equivalent circuit of two parallel Butterworth-Van Dyke circuits, we have simultaneously obtained accurate and precise impedance responses of two one-face sealed crystals to changes in solution density and viscosity, temperature, conductance, and/or electrode mass. A series of sucrose aqueous solutions, ferri-/ferrocyanide redox switching, hot water cooling, a series of NaClO4 aqueous solutions, bovine serum albumin adsorption and silver electrodeposition/stripping were selected as model systems for such purposes. Galvanostatic charging/discharging reactions at positive and negative poles in a Ni-Zn battery were synchronously monitored, with some quartz crystal microbalance (QCM) insights into the second reduction process of nickel hydroxide film. In all c ases, the crystal immersion angle effect was found to be negligible. The present method as a versatile one is highly recommended for informative two-electrode monitoring of two concurrent chemical or biological events, or for check and/or compensation of effects due to solution density, viscosity, temperature and/orconductance during QCM researches.

A simultaneous EQCM-fluorescence method has been proposed as a novel and informative tool for the study of the adsorption/desorption and oxidation for vitamin B6 (pyridoxol) at a polycrystalline Au electrode in aqueous KOH. The oxidation of pyridoxol was irreversible and accompanied by a strong electrogenerated fluorescence emission peaking at 443nm when excited at 360nm. Theadsorption and desorption of the oxidation product were found in the double layer region and were discussed by analyzing the simultaneous fluorescence and EQCM data. In addition, the voltammetrically electrogenerated fluorescence is proposed as a new and sensitive method for assay of pyridoxol with satisfactory results.